Advantech AIMB-766 Manuale Utente Scaricare il pdf (Pagina 17)

9 ACP-1010 User Manual

Chapter 2 System Setup

2.4 Installing the Motherboard and Riser Card

ACP-1010MB supports a variety of Advantech ATX or microATX motherboards. It

can support an add-on card via the riser card. To install the motherboard and riser

card, please refer to the following steps:

1. A yellow label is located inside the chassis bottom. (see Figure 2.4) It shows the

stand-off spacer location for attaching specific ATX / MicroATX motherboards.

Users can find the stand-off spacer in the accessory box (see Figure 2.5). Be

sure to follow the instructions and fasten the motherboard onto the chassis with

the correct stand-off spacer location.

Figure 2.4 Yellow label indicating stand-off locations

Figure 2.5 Stand-off spacer

2. The accessory attaches 2 motherboard I/O shields. Choose the correct one to

be installed on the rear plate of the chassis.

3. Fix the motherboard in the chassis with screws.

4. Plug in the 20/24-pin ATX power connector and +12 V power connector from the

power supply, also the 9-pin USB connectors from the front panel of the chassis.

5. Connect the POWER SW, RESET SW, LAN LED from chassis to mother board

and HDD LED cables from the alarm board to the motherboard.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Nessun commento

Advantech AIMB-766 Manuale Utente Pagina 17