Advantech PCN-6351 Series Manuale Utente Scaricare il pdf (Pagina 10)

Chapter 1 Hardware Configuration 7

OpenOpen

Open

ClosedClosed

Closed

Closed 2-3Closed 2-3

Closed 2-3

1.5 Jumper Settings

This section tells how to set the jumpers to configure your card. It

gives the card default configuration and your options for each jumper.

After you set the jumpers and install the card, you will also need to

run the BIOS Setup program (discussed in Chapter 3) to configure the

serial port addresses, floppy/hard disk drive types and system operat-

ing parameters. Connections, such as hard disk cables, are explained

in Chapter 2.

For the location of each jumper, see the board layout diagram shown

earlier in this chapter.

You configure your card to match the needs of your application by

setting jumpers. A jumper is the simplest kind of electric switch. It

consists of two metal pins and a small metal cap (often protected by a

plastic cover) that slides over the pins to connect them. To "close" a

jumper, connect the pins with the cap. To "open" a jumper, remove

the cap. Sometimes a jumper will have three pins, labeled 1, 2 and 3.

In this case, connect either pins 1 and 2 or 2 and 3.

You may find a pair of needle-nose pliers useful for setting the

jumpers.

If you have any doubts about the best hardware configuration for your

application, contact your local distributor or sales representative

before you make any changes.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 100 101

Nessun commento

Advantech PCN-6351 Series Manuale Utente Pagina 10