Advantech PCA-6289 Manuale Utente Scaricare il pdf (Pagina 29)

19 Chapter 2

2.4.7 Boot Other Device

To boot another device, choose "Enabled" or "Disabled".

2.4.8 Swap Floppy Drive

If the system has two floppy drives, choose "Enabled" to assign physical

drive B to logical drive A and vice-versa. The commands are “Enabled”

or “Disabled.”

2.4.9 Boot Up Floppy Seek

Selection of the command “Disabled” will speed the boot up. Selection of

“Enabled” searches disk drives during boot up.

2.4.10 Boot Up NumLock Status

This feature selects the “power on” state for NumLock. The commands

are “Off” or “On.”

2.4.11 Gate A20 Option

"Normal": A pin in the keyboard controller controls GateA20.

"Fast" (Default): Lets chipset control GateA20.

2.4.12 Typematic Rate Setting

The typematic rate is the rate key strokes repeat as determined by the key-

board controller. The commands are .Enabled. or .Disabled.. Enabling

allows the typematic rate and delay to be selected.

2.4.13 Typematic Rate (Chars/Sec)

This setting controls the speed at which the system registers held-down

keystrokes. The choices range from 6 to 30 Chars/Sec.

2.4.14 Typematic Delay (msec)

This setting controls the time between the display of the first character

and successive characters. There are four delay choices: 250ms, 500ms,

750ms and 1000ms.

2.4.15 Security Option

Select whether the password is required every time the system boots or

only when you enter setup.

"System" The system will not boot, and access to Setup will be denied

if the correct password is not entered at the prompt.

"Setup" The system will boot, but access to Setup will be denied if

the correct password is not entered at the prompt

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 67 68

Nessun commento

Advantech PCA-6289 Manuale Utente Pagina 29