Advantech PCM-3350 Specifiche Scaricare il pdf (Pagina 5)

TCP/IP uses IPv4 addressing schemes to communicate with different Ethernet devices. We will not go

into a discussion about IPv4 addressing but enough to setup communications between the PC104 boards

and the host computer. These are the following options to configure:

Target PC IP address : the IP address labeled next to the PC104 board you are using (e.g 129.219.24.223)

TCP/IP target port : 22222

LAN subnet mask address : 255.255.255.192

TCP/IP gateway address : 129.219.24.193

Leave everything else as default. Click “Apply”.

To create a DOS Loader with Ethernet go back to TargetPC1 > Configuration. On the right side of the

xPC Explorer window click on DOS Loader (see the figure below). In the “Location” box specify a

particular folder where you want to create the DOS Loader files. Click “Apply” first, and then click

“Create DOS Loader”. This will create three files in the folder. These files must now be copied onto the

compact flash(CF) and the CF card inserted into the PC104 CF slot and boot the PC104 up. On the

monitor connected to the PC104 board you should see a message that says communication method is

TCP/IP and it will specify the IPv4 address, subnet mask and gateway you specified. You will later learn

how to download a program to the PC104 using TCP/IP protocol.

1 2 3 4 5 6 7 8 9 10 ... 18 19

Nessun commento

Advantech PCM-3350 Specifiche Pagina 5